LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Air Conditioning) >> Air Conditioning >> Removal And Installation >> Pressure Cutoff Switch >> Removal

Pressure Cutoff Switch: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cover and disconnect the battery ground cable. Refer to Specifications information.
  2. Recover the A/C refrigerant.
  3. Remove the engine cover. Refer to Engine Cover information.
  4. Remove the air intake duct.
    • Remove the bolt.
    • Release the 2 clips.
    GJ0009067
    5. CAUTION: Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
  5. Remove the pressure cutoff switch.
    • Disconnect the electrical connector.
    • Remove and discard the O-ring seal.
    GJ0010262
scientia non olet · About LEMON Manuals