LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Air Conditioning) >> Air Conditioning >> Removal And Installation >> Pressure Cutoff Switch >> Installation

Pressure Cutoff Switch: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the O-ring seals with clean refrigerant oil.
  1. Install the pressure cutoff switch.
    • Clean the components.
    • Install a new O-ring seal.
    • Tighten the cutoff switch to 10 Nm (7 lb.ft).
    • Connect the electrical connector.
  2. Install the air intake duct.
    • Tighten the clips.
    • Tighten the bolt to 10 Nm (7 lb.ft).
  3. Recharge the A/C system.
  4. Install the engine cover. Refer to Engine Cover information.
  5. Connect the battery ground cable and install the cover. Refer to Specifications information.
scientia non olet · About LEMON Manuals