LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Steering Column) >> Steering Column >> Removal And Installation >> Steering Column Lower Shaft >> Removal

Steering Column Lower Shaft: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the steering wheel to the straight ahead position.
    2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  2. Raise and support the vehicle.
  3. Remove the steering column lower universal joint assembly for access.
    • Remove and discard the 2 bolts.
      GJ0009145
  4. Remove the instrument panel lower trim panel. Refer to Instrument Panel Lower Trim Panel information.
  5. Disconnect the steering column lower shaft from the steering column.
    • Remove the bolt.
  6. Remove the steering column lower shaft.
    • Remove the 2 nuts.
    • Release the bearing carrier.
    • Discard the gasket.
      GJ0009535
    7. NOTE: Do not disassemble further if the component is removed for access only.
  7. Remove the bearing carrier.
    • Remove the 2 bolts.
      GJ0009536
scientia non olet · About LEMON Manuals