LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Steering Column) >> Steering Column >> Removal And Installation >> Steering Column Lower Shaft >> Installation

Steering Column Lower Shaft: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bearing carrier.
    • Install a new gasket.
    • Tighten the bolts to 10 Nm (7 lb.ft).
  2. Install the steering column lower shaft.
    • Install a new gasket.
    • Tighten the nuts to 10 Nm (7 lb.ft).
  3. Connect the steering column lower shaft to the steering column.
    • Align the shafts.
    • Tighten the nuts to 30 Nm (22 lb.ft).
  4. Raise the vehicle.
  5. Install the steering column lower universal joint assembly.
    • Align the shafts.
    • Tighten the new bolts to 30 Nm (22 lb.ft).
  6. Install the instrument panel lower trim panel. Refer to Instrument Panel Lower Trim Panel information.
scientia non olet · About LEMON Manuals