Luggage Compartment Lid: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Install the luggage compartment lid decal.
- Remove the backing from the decal.
- Remove the protective cover from the decal.
- Secure the decal to the luggage compartment lid.
- Position and align the decal on the luggage compartment lid.
- Install the luggage compartment lid wiring harness.
- Install both of the rear lamp assemblies.
- Install the nuts.
- Connect the electrical connectors.
- Install the luggage compartment lid finisher.
- Connect the license plate lamp electrical connector.
- Secure the 4 clips.
- Install the 4 bolts.
- Install the grommets.
- Install the license plate lamp housing.
- Install the wiring harness.
- Install the 2 bolts.
- Secure in the 9 clips.
- Connect the electrical connectors.
- Install the luggage compartment lid lock cylinder.
- Tighten the Torx bolt to 3 Nm (2 lb.ft).
- Install the bump stops.
- Install the luggage compartment lid latch assembly.
- Install the 3 Torx bolts.
- Connect the electrical connector.
- Tighten the bolts to 20 Nm (15 lb.ft).
- Connect the luggage compartment lid latch operating cable to the lock cylinder.
- Install the cable.
- With assistance, install the luggage compartment lid.
- Install the 4 nuts.
- Tighten the nuts to 23 Nm (17 lb.ft).
- Install the luggage compartment lid support struts.
- Secure in the 2 clips.
- Install the wiring harness.
- Secure the electrical harness with the clip.
- Connect the 4 electrical connectors.
- Install the luggage compartment lid trim panel.