LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Body Closures) >> Body Closures >> Removal And Installation >> Door >> Removal

Removal And Installation: Door: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cover and disconnect the battery ground cable. Refer to Specifications information.
  2. Remove the front door trim panel. Refer to Front Door Trim Panel information.
  3. Remove the window regulator motor.
    • Disconnect the electrical connector.
    • Remove the 3 Torx screws.
      GJ0009317
  4. Release the front door inner weathershield.
    • Disconnect the 3 electrical connectors.
    • Release the 9 wiring harness clips.
      GJ0009318
  5. Remove the front door inner weathershield.
    • Remove the 12 Torx bolts.
    • Release the front door interior handle cable.
      GJ0009319
  6. Release the door check strap from the body.
    • Remove the 2 Torx screws.
      GJ0010378
  7. Release the door harness from the door.
    • Release the 5 clips.
    • Disconnect the 2 electrical connectors.
    • Release from the locating grommet.
      GJ0010379
    8. NOTE: With assistance remove the component.
  8. Remove the door.
    • Remove the 2 hinge bolts.
      GJ0010380
scientia non olet · About LEMON Manuals