LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Body Closures) >> Body Closures >> Removal And Installation >> Door >> Installation

Removal And Installation: Door: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. With assistance, install the door assembly.
    • Lubricate the hinges and bolts tighten to 25 Nm (18 lb.ft).
  2. Install the door wiring harness.
    • Secure in the grommets.
    • Connect the electrical connectors.
    • Secure the clips.
  3. Install the door check strap.
    • Tighten the Torx screws to 10 Nm (7 lb.ft).
  4. Install the front door inner weathershield.
    • Attach the front door interior handle cable.
    • Tighten the Torx bolt to 10 Nm (7 lb.ft).
  5. Secure the front door inner weathershield.
    • Secure the wiring harness clips.
    • Connect the electrical connectors.
  6. Install the window regulator motor.
    • Install and tighten the Torx screws.
    • Connect the electrical connector.
  7. Install the front door trim panel. Refer to Front Door Trim Panel information.
  8. Connect the battery ground cable and install the cover. Refer to Specifications information.
scientia non olet · About LEMON Manuals