LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Body Closures) >> Body Closures >> Removal And Installation >> Door Check Arm >> Installation

Door Check Arm: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the door check strap.
    • Tighten the Torx screws to 10 Nm (7 lb.ft).
    • Tighten the nuts to 25 Nm (18 lb.ft).
  2. Install the front door inner weathershield.
    • Attach the front door interior handle cable.
    • Tighten the Torx bolt to 10 Nm (7 lb.ft).
  3. Secure the front door inner weathershield.
    • Secure the wiring harness clips.
    • Connect the electrical connectors.
  4. Install the window regulator motor.
    • Install and tighten the Torx screws.
    • Connect the electrical connector.
  5. Install the front door trim panel. Refer to Front Door Trim Panel information.
scientia non olet · About LEMON Manuals