LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Bumpers) >> Bumpers >> Removal And Installation >> Front Bumper >> Installation

Front Bumper: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ambient air temperature sensor.
  2. Install the front bumper.
    • Secure the wiring harness clips.
    • Connect the electrical connector.
    • Tighten the bolts to 45 Nm (33 lb.ft).
  3. Install the air deflectors.
    • Secure the clips.
  4. Install the crush pad.
    • Secure the clips.
    • Vehicles with a pedestrian impact sensor only: Install the additional bolts and tighten to 10 Nm (7 lb.ft).
  5. Install the front bumper cover. See Front Bumper Cover . .
  6. Connect the battery ground cable and install the cover. Refer to Specifications information.
scientia non olet · About LEMON Manuals