LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Convertible Top) >> Convertible Top >> Removal And Installation >> Hydraulic System, Lift Cylinder And Motor >> Removal

Hydraulic System, Lift Cylinder And Motor: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH loadspace trim panel. Refer to Loadspace Trim Panel - Vehicles With: Convertible Top information.
    2. CAUTION: Do not loosen the Allen bolt more than 2 complete turns. Failure to follow this instruction may result in damage to the vehicle.
    NOTE: The ignition must be switched off.
  2. Release the convertible top system pressure.
    • Loosen the Allen bolt up to a maximum of 2 complete turns.
      GJ0010028
  3. Disconnect the convertible top hydraulic pump electrical connectors.
    • Release the 2 electrical connectors from the convertible top pump bracket.
      GJ0010289
  4. Release the convertible top hydraulic pump.
    • Remove the 3 bolts.
      GJ0010029
    5. CAUTION: Always plug any open connections to prevent contamination.
  5. Disconnect the convertible top hydraulic pump hoses.
    • Remove the 3 Allen bolts.
    • Release the hose retaining clamp.
    • Remove and discard the O-ring seals.
      GJ0010290
  6. Remove the convertible top hydraulic pump.
scientia non olet · About LEMON Manuals