LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Convertible Top) >> Convertible Top >> Removal And Installation >> Hydraulic System, Lift Cylinder And Motor >> Installation

Hydraulic System, Lift Cylinder And Motor: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the convertible top hydraulic pump.
  2. Connect the convertible top hydraulic pump hoses.
    • Install new O-ring seals.
    • Attach the hoses and position the retaining clamp.
    • Tighten the Allen bolts to 10 Nm.
  3. Secure the convertible top hydraulic pump.
    • Tighten the bolts to 8 Nm.
  4. Connect the convertible top hydraulic pump electrical connectors.
    • Secure the electrical connectors to the convertible top pump bracket.
  5. Fill the convertible top pump with the correct amount of fluid.
    • Remove the convertible top fluid filler plug.
    • Top-up the convertible top fluid.
    • Install the convertible top fluid filler plug.
  6. Install the RH loadspace trim panel. Refer to Loadspace Trim Panel - Vehicles With: Convertible Top information.
  7. Cycle the convertible top to bleed the hydraulic system.
scientia non olet · About LEMON Manuals