LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Convertible Top) >> Convertible Top >> Removal And Installation >> Convertible Top Tension Cylinder >> Removal

Convertible Top Tension Cylinder: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the convertible top front latches.
    • Depress the switch.
  2. Remove the convertible top hydraulic pump access panel
    • Release the clip.
      GJ0010034
    3. CAUTION: Do not loosen the Allen bolt more than 2 complete turns. Failure to follow this instruction may result in damage to the vehicle.
    NOTE: The ignition must be switched off.
  3. Release the convertible top system pressure.
    • Loosen the Allen bolt up to a maximum of 2 complete turns.
      GJ0010028
  4. Release the convertible top compartment lid.
    • Release using the cable.
      GJ0010035
    5. NOTE: Support as necessary.
  5. Open the convertible top to the position shown.
    GJ0009610
  6. Release the cylinder cover.
    • Remove the 2 Torx screws.
      GJ0010383
  7. Release the hydraulic cylinder.
    • Release the 2 clips.
      GJ0010384
    8. CAUTION: Fluid loss is unavoidable care must be taken to protect the interior of the vehicle.
  8. Disconnect the hydraulic cylinder lines.
    • Carefully release the 2 clips.
    • Withdraw the hydraulic lines from the cylinder, remove and discard the O-rings.
  9. Remove the hydraulic cylinder.
    • Remove and discard the 3 cable ties.
    • RH hydraulic cylinder only: Disconnect the electrical connector.
      GJ0010385
scientia non olet · About LEMON Manuals