LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Convertible Top) >> Convertible Top >> Removal And Installation >> Convertible Top Tension Cylinder >> Installation

Convertible Top Tension Cylinder: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the hydraulic cylinder lines.
    • Lubricate and install the new O-rings.
    • Connect the hydraulic lines to the cylinder.
    • Secure with the clips.
  2. Install the hydraulic cylinder.
    • RH hydraulic cylinder only: Connect the electrical connector.
    • Secure with cable ties.
    • Secure with the clips.
  3. Install the cylinder cover.
    • Tighten the Torx screws.
  4. Close the convertible top.
    5. NOTE: The ignition must be switched off.
  5. Tighten the convertible top system pressure Allen bolt.
    • Tighten to 2 Nm.
      GJ0010028
  6. Install the convertible top hydraulic pump access panel
    • Secure in the clip.
  7. Operate the convertible top fully in each direction.
    • Depress the switch.
scientia non olet · About LEMON Manuals