Convertible Top Material: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Install the convertible top outer material.
- Secure the convertible top material to the frame.
- Secure the front edge of the convertible top material.
- Install the Torx screws.
- Secure the convertible top outer material retaining straps.
- Tighten the Torx bolts to 6 Nm (4 lb.ft).
- Feed the tension cables through the convertible top outer material ensuring the correct routing.
- Attach the tension cables to the convertible top frame.
- Install new clips.
- Secure the convertible top to the rear seal.
- Carefully open the rear seal sufficiently to locate the convertible top outer material.
- Attach the convertible top outer material.
- Clamp the seal to retain the outer material.
- Install the convertible top side seal carriers.
- Install the rivets.
- Attach the seal.
- Install the convertible top front seal carriers.
- Install the spacers.
- Tighten the new Torx bolts to 6 Nm (4 lb.ft).
- Attach the seal.
- Tighten the Torx screws.
- Install the convertible top headliner. See Convertible Top Headliner .