Convertible Top Headliner: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Secure the headliner to the front of the convertible top frame.
- Position the retaining bracket.
- Install and tighten the screws.
- Tighten the bolts to 10 Nm.
- Secure the headliner to the center of the convertible top frame.
- Remove the 5 screws.
- Install and tighten the screws.
- Attach the headliner central tension straps.
- Tighten the Torx bolts to 4 Nm.
- Secure the headliner to the rear of the convertible top frame.
- Install and tighten the screws.
- Attach the headliner rear tension straps.
- Tighten the Torx bolts to 4 Nm.
- Attach the springs.
- Reposition the rear window
- Fold over the rear window to allow access to the headliner retaining screws.
- Fold the rear window into fitted position.
- Secure the heated rear window wires to the headliner.
- Attach the heated rear window wires to the headliner.
- Connect the electrical connectors.
- Secure the rear edge of the convertible top headliner.
- Position the securing bracket.
- Install and tighten the Torx screws.
- Close the convertible top compartment lid.
- Raise the rear of the convertible top.
- Install the header rail upper trim panel. See Header Rail Upper Trim Panel .
- Tighten the convertible top system pressure Allen bolt.
- Install the convertible top hydraulic pump access panel
- Secure in the clip.
- Operate the convertible top fully in each direction.
- Depress the switch.
CAUTION:
Ensure grease from latching mechanisms does not contact the headliner.
NOTE:
Note the fitted position.
NOTE:
Take note of the routing.
NOTE:
Note the fitted position.
NOTE:
Support as necessary.
NOTE:
The ignition must be switched off.