LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Convertible Top) >> Convertible Top >> Removal And Installation >> Convertible Top Compartment Lid >> Installation

Convertible Top Compartment Lid: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the convertible top compartment trim panel.
    • Install and tighten the Torx screws.
    • Secure with the clips.
  2. Install the convertible top compartment molding.
    • Tighten the nuts to 4 Nm (3 lb.ft).
  3. Install the convertible top compartment lid strikers.
    • Tighten the bolts to 9 Nm (7 lb.ft).
  4. Install the convertible top compartment lid lift cylinder spigot.
  5. Install the convertible top compartment lid pad.
    • Secure with the clips.
  6. Install the convertible top compartment lid buffers.
    • Release the clips.
    • Secure in the clips.
  7. Check the convertible top compartment lid profile.
    • Loosen the locknut.
    • Adjust the striker.
    • Check the convertible top compartment lid profile.
  8. With assistance, install the convertible top compartment lid.
    • Tighten the bolts to 25 Nm (18 lb.ft).
  9. Attach the convertible top compartment lid lift cylinder.
    • Secure with the clip.
  10. Close the convertible top compartment lid.
    • Remove the support.
    • Depress the switch.
  11. If required, adjust the convertible top compartment lid.
scientia non olet · About LEMON Manuals