LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Convertible Top) >> Convertible Top >> Removal And Installation >> Convertible Top Compartment Lid Lift Cylinder >> Installation

Convertible Top Compartment Lid Lift Cylinder: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the convertible top compartment lid lift cylinder.
    • Secure with the clip.
  2. Install the convertible top compartment lid lift cylinder cover.
    • Attach the lift cylinder.
    • Secure with the clip.
  3. Secure the convertible top compartment lid lift cylinder.
    • Connect the 2 fluid lines.
    • Connect the electrical connector.
    4. NOTE: Support as necessary.
  4. Close the convertible top compartment lid.
    • Raise the rear of the convertible top.
    5. NOTE: The ignition must be switched off.
  5. Tighten the convertible top system pressure Allen bolt.
    • Tighten to 2 Nm.
  6. Cycle the convertible top to bleed the hydraulic system.
  7. Check the convertible top fluid level.
  8. Install the convertible top hydraulic pump access panel
    • Secure in the clip.
scientia non olet · About LEMON Manuals