LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Convertible Top) >> Convertible Top >> Removal And Installation >> Convertible Top Compartment Lid Latch Cables >> Installation

Convertible Top Compartment Lid Latch Cables: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the convertible top lid release latch cables.
    • Release from the 7 clips.
  2. Attach the convertible top lid lift cylinder bracket release cables.
    • Loosen the 2 locknuts.
    • Remove the clip.
  3. Attach the convertible top latch release cables.
    • Secure with the clips.
    • Tighten the Torx bolts.
  4. Attach the convertible top lid lift cylinder.
    • Secure with the clip.
  5. Secure the convertible top lid lift cylinder bracket.
    • Remove the 2 lower nuts.
    • Loosen the upper retaining nut.
  6. Secure the convertible top lid position switch.
    • Tighten the Torx bolts.
  7. Secure the LH convertible top lid latch.
    • Tighten the bolts to 10 Nm (7 lb.ft).
  8. Secure the convertible top electrical connector.
    • Connect the electrical connector.
    • Secure with the clip.
  9. Install the RH loadspace trim panel. Refer to Loadspace Trim Panel - Vehicles With: Convertible Top information.
  10. Connect the battery ground cable and install the cover. Refer to Specifications information.
  11. Close the convertible top compartment lid.
  12. If required, adjust the convertible top compartment lid.
scientia non olet · About LEMON Manuals