LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Convertible Top) >> Convertible Top >> Removal And Installation >> Convertible Top Compartment Lid Latch And Cable Assembly >> Removal

Convertible Top Compartment Lid Latch And Cable Assembly: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Support as necessary.
  1. Open the convertible top to the position shown.
    • Depress the switch.
      GJ0009610
  2. Remove the cover and disconnect the battery ground cable. Refer to Specifications information.
  3. Remove the RH loadspace trim panel. Refer to Loadspace Trim Panel - Vehicles With: Convertible Top information.
  4. Release the convertible top electrical connector
    • Release from the clip.
    • Disconnect the electrical connector.
      GJ0010274
  5. Release the convertible top lid latch and cable assembly.
    • Release the cables from the 7 clips.
      GJ0010279
  6. Release the convertible top lid lift cylinder.
    • Release the clip.
      GJ0010275
  7. Release the LH convertible top lid latch.
    • Remove the 3 bolts.
      GJ0010271
  8. Release the convertible top lid RH latch.
    • Remove the 3 bolts.
      GJ0010280
  9. Remove the convertible top lid latch and cable assembly.
    • Remove the 2 lower nuts.
    • Loosen the upper retaining nut.
    • Release the emergency release cable.
      GJ0010281
scientia non olet · About LEMON Manuals