Convertible Top Compartment Lid Latch And Cable Assembly: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Install the convertible top latch and cable assembly.
- Attach the emergency release cable.
- Tighten the nuts to 10 Nm (7 lb.ft).
- Secure the convertible top lid RH latch.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Secure the LH convertible top lid latch.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Attach the convertible top lid lift cylinder.
- Secure with the clip.
- Secure the convertible top lid latch and cable assembly.
- Connect the electrical connector.
- Secure the cables in the clips.
- Secure the convertible top electrical connector.
- Connect the electrical connector.
- Secure with the clip.
- Install the RH loadspace trim panel. Refer to Loadspace Trim Panel - Vehicles With: Convertible Top information.
- Connect the battery ground cable and install the cover. Refer to Specifications information.
- Close the convertible top compartment lid.
- Raise the rear of the convertible top.
NOTE:
Support as necessary.