LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Exterior Lighting) >> Exterior Lighting >> General Procedures >> Front Fog Lamp Adjustment

Front Fog Lamp Adjustment

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the beam setting equipment to one fog lamp.
    2. NOTE: The fog lamp beam should be set at 1.2% below the horizontal and parallel.
  2. Check the fog lamp beam alignment.
  3. Turn the steering on to full lock for access.
    4. NOTE: Wheel shown removed for clarity.
  4. Release the front of the fender splash shield.
    • Remove the 7 Torx bolts.
    • Tie the splash shield aside.
      GJ0008882
  5. Adjust the fog lamp using the thumb wheel.
    GJ0010339
  6. Install the fender splash shield.
    • Tighten the Torx bolts.
  7. To adjust the second fog lamp, repeat the above procedure.
scientia non olet · About LEMON Manuals