Symptom Chart
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
| Symptom | Possible Causes | Action |
|---|---|---|
| Low beam lamp(s) inoperative |
|
Check the bulb and fuse condition (see visual inspection). Check the headlamp circuits. Check the lighting control switch function. Check the left-hand steering column multifunction switch operation. Refer to the electrical guides. Check for DTCs indicating a headlamp or related circuit fault. |
| High beam lamp(s) inoperative | ||
| Low beam lamp(s) dim |
|
Check the bulb condition and rating. Check the tourist lever is set correctly. Check the headlamp circuits. Check the lighting control switch function. Check the left-hand steering column multifunction switch function. Refer to the electrical guides. |
| High beam lamp(s) dim | ||
| Low beam lamp(s) stuck on |
|
Check the headlamp circuits. Check the lighting control switch function. Check the left-hand steering column multifunction switch operation. Check the headlamp timer function. Refer to the electrical guides. Check for DTCs indicating a headlamp circuit fault |
| High beam lamp(s) stuck on | ||
| Headlamp low/high beam switching function inoperative |
|
Check the headlamp circuits. Check the left-hand steering column multifunction switch operation. Check the xenon lamp shutter mechanism operation. Refer to the electrical guides. Check for DTCs indicating a headlamp circuit fault |
| Warning lamp(s) inoperative |
|
Check the fuse(s) (see visual inspection). Check the lighting control switch function. Check the left-hand steering column multifunction switch function. Check the warning lamp circuits. Refer to the electrical guides. Check for DTCs indicating an instrument cluster or CAN system fault. |
| Headlamp Wet - Internal |
|
Check for outstanding Technical Service Bulletins (TSBs) relating to 'Headlamp Internal Condensation'. Carry out the instructions in the service bulletin to determine if the fault is related to condensation or water ingress. |