LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Handles, Locks, Latches & Entry Systems) >> Handles, Locks, Latches And Entry Systems >> Removal And Installation >> Hood Latch >> Installation

Hood Latch: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pedestrian protection latch actuator.
    • Connect the electrical connector.
    • Tighten the new Torx bolts to 9 Nm (7 lb.ft).
  2. Install the hood latch.
    • Attach the latch cable.
  3. Install the hood switch.
    • Secure in the clips.
  4. Secure the hood latch.
    • Connect the electrical connectors.
    • Tighten the bolts to 10 Nm (7 lb.ft).
  5. Install the pedestrian protection actuator and bracket. Refer to Pedestrian Protection Hood Actuator LH and Pedestrian Protection Hood Actuator RH information.
scientia non olet · About LEMON Manuals