Pinpoint Test A: Single door will not open from the outside (but opens from the inside)

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

Check the exterior door release cable to exterior door handle is installed correctly
Remove the door trim panel as necessary. Refer to Front Door Trim Panel information. Refer to Rear Door Trim Panel information.

Check the exterior door release cable is correctly installed to the exterior door handle

Is the cable correctly installed?

YES: Go to step 2.

NO: Connect the door release cable correctly. If the cable is damaged, install a new door release cable . Test the system for normal operation.
Check the exterior door handle release connection to the door latch

Confirm the exterior door handle release connection to the door latch is installed correctly

Is the exterior door handle release cable installed correctly?

YES: Refer to Pinpoint Test C .

NO: Connect the door release cable correctly. If the cable is damaged, install a new door release cable . Test the system for normal operation.