Overhead Console Switch Molding: Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Remove the overhead console. See Overhead Console .
- Remove the front intrusion sensor.
- Remove the garage door opener module.
- Remove the printed circuit board (PCB) cover.
- Using a 5mm drill bit, carefully drill out and remove the 4 plastic fixing heads.
- Remove the PCB.
- Remove the two switch moldings.
- Remove the foam pad.
- Carefully remove sunroof rocker switch for reuse in the new rear switch molding.
NOTE:
Where installed.
NOTE:
Where installed.
CAUTION:
Make sure that only the head of the fixing is removed. Do not drill any deeper than necessary. Failure to follow this instruction may result in damage to the component.