LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Instrument Panel & Console) >> Instrument Panel And Console >> Removal And Installation >> Instrument Panel Lower Trim Panel >> Removal

Instrument Panel Lower Trim Panel: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel end trim panel.
    • Open the front door for access.
    • Carefully release the 3 clips.
    GJ0009433
  2. Remove the instrument panel driver's side reinforcement trim panel.
    • Carefully release the 4 clips.
    GJ0009401
    3. CAUTION: Care must be taken to avoid damage to the mating surfaces.
  3. Carefully release and remove the rheostat switch assembly.
    • Disconnect the electrical connector.
    GJ0009434
    4. CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
  4. Remove the driver's side footwell trim panel.
    • Carefully release the 3 clips.
    GJ0009435
  5. Release the MOST diagnostic port.
    • Carefully release the clip.
    GJ0009436
  6. Remove the instrument panel, lower trim panel.
    • Remove the 3 Torx bolts.
    • Remove the 2 Torx screws.
    • Release the 2 clips.
    • Release the vehicle diagnostic port.
    GJ0009437
scientia non olet · About LEMON Manuals