LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Battery & Charging System - General Information) >> Battery And Charging System - General Information >> Diagnostic Procedures >> Charging System >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
Symptom Possible Cause Action
Battery Not Charging warning displayed on message center
  • Fuse 5 RJB
  • Front End Accessory Drive (FEAD) belt tension
  • Generator fault
  • ECM
  • Instrument cluster fault
  • Controller Area Network (CAN) fault
Check Fuse 5 RJB. Check the battery condition and state of charge. Refer to the battery care manual. Check the FEAD belt tension. Refer to Accessory Drive information. Check ECM and instrument cluster for DTCs and refer to relevant DTC Index. and Refer to Electronic Engine Controls or Refer to Electronic Engine Controls information. Refer to Instrument Cluster information. Refer to Communications Network information.
Battery keeps discharging, no warning message displayed on message center
  • No ignition power from CJB
  • Battery quiescent drain
  • Battery fault
  • FEAD belt tension
  • Generator pulley fault
  • Generator failure
For ignition power circuit tests. Refer to Pinpoint Test B . Check the quiescent drain. Check the battery condition and state of charge, refer to the battery care manual. See Battery Charging . Check the FEAD belt tension. and Refer to Accessory Drive information. Check RJB for DTCs B2A9016, B2A9116, Note: if battery requires replacing and these DTCs were logged, complete and return the battery report form listing the DTCs, see battery care manual. Check ECM for DTCs and refer to relevant DTC Index. and Refer to Electronic Engine Controls or Refer to Electronic Engine Controls information. Check the generator pulley does not turn independently of the generator
Generator noisy
  • FEAD belt tension
  • FEAD belt
  • FEAD belt tensioner
  • FEAD belt idler pulleys
  • Generator failure
For noisy generator tests. Refer to Pinpoint Test C .
Radio interference
  • Generator
  • Wiring harness
For radio interference tests. Refer to Pinpoint Test D .