LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Battery & Charging System - General Information) >> Battery And Charging System - General Information >> Diagnostic Procedures >> Charging System >> DTC Index

DTC Index

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00.
NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval program is in operation, prior to the installation of a new module/component.
NOTE: Generic scan tools may not read the codes listed, or may read only five digit codes. Match the five digits from the scan tool to the first five digits of the seven digit code listed to identify the fault (the last two digits give extra information read by the manufacturer-approved diagnostic system).
NOTE: When performing electrical voltage or resistance tests, always use a digital multimeter (DMM) accurate to three decimal places, and with an up-to-date calibration certificate. When testing resistance, always take the resistance of the DMM leads into account.
NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
NOTE: If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.
DTC Description Possible Cause Action
P163200 Generator faults sensor/circuit
  • Charging system fault
Refer to Pinpoint Test A .
B2A9016 Battery low
  • Circuit voltage below threshold
Check battery is in fully charged and serviceable condition (if battery requires replacing and this DTC is logged, complete and return battery report form listing this DTC), refer to the battery care manual
B2A9116 Battery discharged
  • Circuit voltage below threshold
Check battery is in fully charged and serviceable condition (if battery requires replacing and this DTC is logged, complete and return battery report form listing this DTC), refer to the battery care manual