Windshield Glass - (Vehicles Without: Convertible Top): Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always protect paintwork and glass when removing exterior components.
CAUTION:
Always protect the interior components when removing body glass.
CAUTION:
Lay the glass on felt covered supports. Do not stand on edge as this can cause chips which subsequently develop into cracks.
NOTE:
The following equipment is required: l Cutting wire and handles l Kent knife l Glazing knife l Windshield replacement kit l Sealant applicator gun l Suction cups l A felt covered table or stand to support glass
- Remove the plenum chamber panel. Refer to Cowl Vent Screen information.
- Remove both A-pillar trim panels. Refer to A-Pillar Trim Panel information.
- Disconnect the heated windshield electrical connectors.
- Remove the rain sensor. Refer to Rain Sensor information.
- With assistance, remove the windshield glass.
- Carefully cut through the sealant using a glazing knife or cutting wire.
- Attach the suction cups.
NOTE:
LH illustration shown, RH is similar.
WARNING:
Eye protection must be worn.
CAUTION:
The two shaded areas in the graphic indicate the position of a body patch, that covers a body joint. Take care not to trap the cutting tool in the body joint.