LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Glass, Frames & Mechanisms) >> Glass, Frames And Mechanisms >> Removal And Installation >> Windshield Glass - (Vehicles With: Convertible Top) >> Removal

Windshield Glass - (Vehicles With: Convertible Top): Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to Cowl Vent Screen information.
  2. Refer to A-Pillar Trim Panel information.
  3. Refer to Rain Sensor information.
  4. Remove the polyurethane (PU) adhesive cap and heat the PU adhesive for a minimum of 30 minutes.
    GJ0011307
  5. See figure.
    GJ0011308
    6. CAUTION: Protect the surrounding components.
    CAUTION: Protect the surrounding paintwork to avoid damage.
  6. See figure
    GJ0011309
    7. WARNING: This step requires the aid of another technician.
  7. See figure
    GJ0011310
scientia non olet · About LEMON Manuals