LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Glass, Frames & Mechanisms) >> Glass, Frames And Mechanisms >> Removal And Installation >> Windshield Glass - (Vehicles With: Convertible Top) >> Installation

Windshield Glass - (Vehicles With: Convertible Top): Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure that the mating faces are clean and free of foreign material.
    • Prepare the window glass, window glass flange and trimmed PU adhesive in accordance with the instructions included with the PU adhesive kit.
    GJ0011311
    2. CAUTION: Touching the adhesive surface will impair rebonding.
  2. See figure
    GJ0011312
    3. CAUTION: Make sure that no excess sealant residue is evident.
    • If water is used as a means for the leak check, then allow sealant to dry before testing.
    • Spray water around the windshield glass, mark any area that leaks. Dry the windshield glass and sealant before applying additional sealant.
    GJ0011314
  4. See figure.
    GJ0011308
  5. Refer to Rain Sensor information.
  6. Refer to A-Pillar Trim Panel information.
  7. Refer to Cowl Vent Screen information.
scientia non olet · About LEMON Manuals