LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Glass, Frames & Mechanisms) >> Glass, Frames And Mechanisms >> General Procedures >> Door Window Motor Initialization

Door Window Motor Initialization

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: After the battery has been disconnected it is necessary to initialize each door window motor separately to operate the "one-touch" up function.
  1. Operate the window control switch until the door window glass is in the fully closed position, continue to operate the window control switch for a further two seconds.
  2. Release the window control switch.
  3. Operate the window control switch in the closed position and continue to operate the window control switch for a further two seconds.
  4. Operate the window control switch until the door window glass is in the fully open position ("one-touch" down).
    5. NOTE: If the door window motor initialization has been completed correctly, when the window control switch is operated, the door window glass should move to the fully closed position ("one-touch" up) automatically.
    NOTE: If the door window glass does not fully close automatically ("one-touch" up), repeat the complete procedure.
  5. Operate the window control switch once to the close position.
  6. Repeat the door window motor initialization for each door window motor.
scientia non olet · About LEMON Manuals