Wiper Pivot Arm: Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always protect paintwork and glass when removing exterior components.
- Open the hood.
- Remove the RH air intake cover.
- Remove the 3 clips.
- Remove the windshield wiper arms.
- Remove the 2 access plugs.
- Remove the 2 nuts.
- Disconnect the 2 washer jet blocks from the cowl vent screen.
- Remove the wiper blades.
- Release the 2 clips.
CAUTION:
Wipers arms do not lock in the upright position. Windshield damage may occur if the wiper pivot arms are allowed to drop against the glass.
NOTE:
RH illustration shown, LH is similar