LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wipers & Washers) >> Wipers And Washers >> Removal And Installation >> Wiper Pivot Arm >> Installation

Wiper Pivot Arm: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiper blades.
    • Position the locating clip in the upright position.
    • Position the blade at the end of the arm.
    • Secure the clip.
    • Repeat for the other side
    2. CAUTION: Incorrect fitting of the wiper pivot arms will result in damage to the bonnet on closure.
    NOTE: Align the wiper with the mark on the windscreen.
    NOTE: LH illustration shown, RH is similar.
  2. Install the windshield wiper arm.
    • Make sure the spindle is free from contamination.
    • Apply gentle pressure on the pivot arm hinge to make sure the pivot arm is located evenly.
    • Lightly tighten the nut.
    • Align the tip of the wiper blade with the mark on the windshield.
    • Tighten the nut to 23 Nm (17 lb.ft).
    • Install the covers.
    • Connect the washer jet hose block.
    • Repeat for the other side.
    GJ0009362
  3. Install the RH air intake cover.
scientia non olet · About LEMON Manuals