LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wipers & Washers) >> Wipers And Washers >> Removal And Installation >> Windshield Wiper Motor - (RHD) >> Removal

Windshield Wiper Motor - (RHD): Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the plenum chamber panel. Refer to Cowl Vent Screen information.
  2. Remove the coolant expansion tank. Refer to COOLANT EXPANSION TANK information.
  3. Remove the engine compartment braces.
    • Release the grommet.
    • Remove the 4 Torx bolts.
    • Repeat the above procedure for the other side.
    GJ0009346
  4. Remove the secondary bulkhead panel.
    • Remove the nut.
    • Release the 4 clips.
    GJ0010001
  5. Release the engine compartment RH side wall.
    • Remove the 4 bolts.
    GJ0010002
  6. Remove the windshield wiper motor.
    • Disconnect the electrical connector.
    • Remove the 3 bolts.
    GJ0010003
scientia non olet · About LEMON Manuals