LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wipers & Washers) >> Wipers And Washers >> Removal And Installation >> Windshield Wiper Motor - (RHD) >> Installation

Windshield Wiper Motor - (RHD): Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the windshield wiper motor.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    • Connect and secure the electrical connector.
  2. Install the engine compartment RH side wall.
    • Tighten the bolts to 6 Nm (4 lb.ft).
  3. Install the secondary bulkhead panel.
    • Carefully secure the clips.
    • Tighten the nut to 4 Nm (3 lb.ft).
  4. Install the engine compartment braces.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Install the grommet.
    • Repeat the above procedure for the other side.
  5. Install the coolant expansion tank. Refer to COOLANT EXPANSION TANK information.
  6. Remove the plenum chamber panel. Refer to Cowl Vent Screen information.
scientia non olet · About LEMON Manuals