LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wipers & Washers) >> Wipers And Washers >> Removal And Installation >> Windshield Wiper Motor - (LHD) >> Removal

Windshield Wiper Motor - (LHD): Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cover and disconnect the battery ground cable. Refer to Specifications information.
    2. WARNING: Do not work on or near the engine if the engine is hot. Failure to follow these instructions may result in personal injury.
  2. Remove the cowl vent screen. Refer to Cowl Vent Screen information.
  3. Remove the engine cover. Refer to ENGINE COVER information.
    4. CAUTION: Care must be taken whilst removing the engine compartment bolts. Failure to follow this instruction may result in damage to the A/C pipes.
    NOTE: Right-hand shown, left-hand similar.
  4. Remove the engine compartment braces.
    • Release the grommet.
    • Remove the 4 Torx bolts.
    • Repeat the above procedure for the other side.
    GJ0009346
  5. Detach the wiring harness.
    • Release the 3 clips.
    GJ0009347
  6. Using a suitable tool, remove the hood release cable clip.
    GJ0009348
  7. Remove the secondary bulkhead center panel.
    • Remove the nut.
    • Release the 4 clips.
    GJ0009349
  8. Release the brake booster vacuum hose.
    • Release the grommet.
    GJ0009350
  9. Release the secondary bulkhead RH panel.
    • Remove the air conditioning (A/C) pipe bracket bolt.
    • Remove the coolant expansion tank mounting bracket bolt.
    • Remove the remaining 2 bolts.
    GJ0009351
  10. Disconnect the windshield wiper motor electrical connector.
    • Detach the wiring harness clip.
    GJ0009352
  11. Remove the windshield wiper motor and linkage mechanism.
    • Remove the 3 bolts.
    GJ0009353
  12. Disconnect the connecting rod.
    GJ0009354
    13. NOTE: Note the original position of the windshield wiper motor crank arm.
  13. Remove the windshield wiper motor.
    • Rotate the windshield wiper motor crank arm 90 degrees clockwise.
    • Remove the 3 bolts.
    GJ0009355
scientia non olet · About LEMON Manuals