Windshield Wiper Motor - (LHD): Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Rotate the windshield wiper motor crank arm 90 degrees clockwise.
- Install the windshield wiper motor.
- Tighten the 3 bolts to 5 Nm.
- Rotate the windshield wiper motor crank arm 270 degrees clockwise to the original position.
- Install the windshield wiper motor and linkage mechanism.
- Loosely install the 3 bolts.
- Tighten bolt 1 to 9 Nm.
- Tighten bolt 2 to 9 Nm.
- Tighten bolt 3 to 9 Nm.
- Connect and secure the electrical connector.
- Install the secondary bulkhead RH panel.
- Tighten the 4 bolts to 4 Nm.
- Install the secondary bulkhead center panel.
- Attach the hood release cable clip.
- Attach the 3 wiring harness clips.
- Secure the 4 clips.
- Tighten the nut to 4 Nm.
- Position the brake booster vacuum hose to one side.
- Position and secure the grommet.
- Install the engine compartment braces.
- Tighten the Torx bolts to 55 Nm.
- Install the grommet.
- Repeat the above procedure for the other side.
- Install the engine cover. Refer to ENGINE COVER information.
- Connect the battery ground cable and install the cover. Refer to Specifications information.
- Carry out the windshield wiper motor park operation.
- Switch the ignition on.
- Turn on the windshield wipers and make sure that the wiper spindles perform a full cycle.
- Turn off the windshield wipers.
- Switch the ignition off.
- Install the cowl vent screen. Refer to Cowl Vent Screen information.
NOTE:
Note the original position of the windshield wiper motor crank arm.