LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wipers & Washers) >> Wipers And Washers >> Removal And Installation >> Windshield Washer Reservoir >> Installation

Windshield Washer Reservoir: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rubber mount.
  2. Install the filler neck seal.
  3. Install the windshield washer pump.
    • Install a new seal.
  4. Install the headlamp washer pump.
    • Install a new seal.
    5. NOTE: Do not disassemble further if the component is removed for access only.
  5. Install the washer reservoir low level sensor.
    • Install a new seal.
    6. NOTE: Align to the position noted on removal.
  6. Install the windshield washer reservoir.
    • Connect the washer jet hoses.
    • Connect and secure the electrical connectors.
    • Tighten the bolts to 6 Nm (4 lb.ft).
  7. Install the windshield washer reservoir filler neck.
    • Release the clip.
  8. Install the fender splash shield. Refer to Fender Splash Shield information.
  9. Refill the washer reservoir.
scientia non olet · About LEMON Manuals