Windshield Washer Pump: Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle.
- Remove the RH fender splash shield. Refer to Fender Splash Shield information.
- Drain the washer reservoir fluid.
- Position a container to collect the fluid.
- Remove the windshield washer pump.
- Disconnect the washer jet hose.
- Disconnect the electrical connector.
- Remove and discard the seal.
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.