LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Supplemental Restraint System) >> Supplemental Restraint System >> Removal And Installation >> Roll Over Protection Unit >> Removal

Roll Over Protection Unit: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cover and disconnect the battery ground cable. Refer to SPECIFICATIONS information.
  2. Make the SRS system safe. Refer to Supplemental Restraint System (SRS) Health and Safety Precautions .
  3. Remove the rear seat backrest. Refer to Rear Seat Backrest information.
  4. Release the rear seat backrest trim panel.
    • Remove the 2 clips.
    • Remove the 2 bolts.
    • Position the rear seat backrest trim panel aside.
      GJ0010286
  5. Remove the rear seat backrest retaining bracket.
    • Remove the 2 nuts and 2 bolts.
      GJ0009485
  6. Remove the roll over protection unit.
    • Disconnect the electrical connector.
    • Remove the 4 Torx bolts.
      GJ0009486
scientia non olet · About LEMON Manuals