LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Supplemental Restraint System) >> Supplemental Restraint System >> Removal And Installation >> Passenger Air Bag Module >> Installation

Passenger Air Bag Module: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the passenger air bag module.
    • Tighten the Torx bolts to 3 Nm (2 lb.ft).
  2. Install the heater duct.
    • Install the Torx screws.
  3. Connect the passenger air bag module electrical connectors.
  4. Connect the passenger air bag ground cable.
    • Install the Torx bolt and tighten to 6 Nm (4 lb.ft).
  5. Install the instrument panel upper trim.
    • With assistance, align the components.
    • Install the compression limiters.
    • Install and tighten the Torx screws.
  6. Install the in-vehicle temperature sensor.
    • Position the electrical harness.
    • Connect and secure the electrical connector.
    • Install the Torx screw.
  7. Install the instrument cluster.
    • Connect and secure the electrical connectors.
    • Install the screws.
  8. Install the instrument cluster surround.
    • Install the screws.
  9. Install the MOST diagnostic port.
    • Secure the clip.
  10. Install the instrument panel, lower trim panel.
    • Install and secure the diagnostic socket.
    • Align the clips.
    • Install the Torx screws.
    • Install the Torx bolts and tighten to 6 Nm (4 lb.ft).
  11. Install the rheostat switch assembly and align the instrument panel lower trim panel.
    • Secure the switch assembly clips.
    • Connect the switch assembly electrical connector.
  12. Install the glove compartment.
    • Install the lamp assembly.
    • Connect and secure the electrical connectors.
    • Tighten the Torx screws.
  13. Install the passenger side register.
    • Install the Torx screws.
  14. Install the instrument panel passenger side reinforcement trim panel.
    • Align the pegs and secure with the clips.
  15. Install the driver side register trim panel.
    • Install the Torx screws.
  16. Install the instrument panel driver's side reinforcement trim panel.
    • Align the pegs and secure with the clips.
    17. NOTE: The Torx screws may not be fitted.
  17. Carefully install the center register.
    • Install the Torx screws.
  18. Install the navigation system display module. Refer to Navigation System Display Module information.
  19. Install the instrument panel. Refer to Instrument Panel information.
  20. Connect the battery ground cable and install the cover. Refer to SPECIFICATIONS information.
  21. Connect WDS to the vehicle and configure a new module.
scientia non olet · About LEMON Manuals