LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Supplemental Restraint System) >> Supplemental Restraint System >> Removal And Installation >> Front Passenger Seat Occupant Classification Sensor >> Installation

Front Passenger Seat Occupant Classification Sensor: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front seat cushion cover.
  2. Secure the passenger seat cushion and occupant classification sensor assembly.
    • Connect and secure the electrical connectors.
    • Secure the Velcro strap.
    • Attach the clips.
  3. Secure the occupant classification assembly to the seat cushion frame.
    • Secure with the clips.
  4. Secure the harness to the seat airbag and backrest frame.
    • Connect the electrical connector.
    • Secure the wiring harness with the clip.
  5. Attach the harness to the lumbar assembly.
    • Connect the electrical connectors.
    • Secure with the clips.
  6. Secure the front seat backrest cover rear panel retaining clips.
    • Attach to the seat frame.
    • Attach to the backrest cover.
  7. Attach the harness assembly to the module bracket.
    • Connect the electrical connectors.
    • Secure the electrical connectors.
    • Secure the wiring harness in the clips.
    • Install and tighten the Torx screws.
  8. Secure the seat module bracket.
    • Connect the electrical connectors.
    • Secure the wiring harness in the clips.
    • Secure the harness with a cable tie.
    • Tighten the Torx bolts to 10 Nm (7 lb.ft).
  9. Secure the front seat backrest cover lower tension straps.
  10. Install the front seat cushion outer trim panel.
    • Connect the electrical connector.
    • Secure in the clips.
  11. Secure the front seat cushion outer trim panel.
    • Tighten the Torx screws.
  12. Install the front seat hinge covers.
    • Attach the hinge cover retainers.
    • Tighten the Torx screws.
  13. Install the front seat. Refer to FRONT SEAT information.
  14. Connect the battery ground cable and install the cover. Refer to Specifications information.
  15. Using IDS, calibrate a new front seat cushion.
    1. * Select the 'Vehicle Configuration' tab.
    2. * Select ' Setup and Configuration'.
    3. * Select 'Seats'.
    4. * Select 'Seat Cover Replacement'.
scientia non olet · About LEMON Manuals