LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Front End Body Panels) >> Front End Body Panels >> Removal And Installation >> Radiator Splash Shield >> Removal

Radiator Splash Shield: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. NOTE: Note the fitted position of the washers.
  3. Remove the radiator splash shield.
    • Remove the 21 Torx bolts.
    • Remove the 2 screws.
      GJ0008899
  4. NOTE: Do not disassemble further if the component is removed for access only.
  5. Remove the 13 clips.
  6. Remove the 2 air deflectors.
    • Release the 2 clips.
      GJ0008900