Upper Arm: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Remove the LH rear wheel and tire. Refer to WHEEL AND TIRE information.

CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.

NOTE: Some fluid spillage is inevitable during this operation.

NOTE: Note the fitted position.

Disconnect the brake hose from the brake caliper.
- Using the special tool, press and hold the brake pedal.
- Remove and discard the two sealing washers.
Release the rear wheel speed sensor lead.
Remove the LH upper arm.
- LH rear: Remove the upper arm 2 nuts and bolts.
- Remove and discard the nut.