Tie Bar: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Install the tie rod.
- Tighten the new inner nut to 90 Nm (59 lb.ft).
- Tighten the new outer nut to 55 Nm (41 lb.ft).
- Install the wheel and tire. Refer to WHEEL AND TIRE information.
- Using only four-wheel alignment equipment approved by Jaguar, check and adjust the wheel alignment.
NOTE:
Use an additional wrench to prevent the ball joint rotating.