LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Rear Suspension) >> Rear Suspension >> Removal And Installation >> Stabilizer Bar Link >> Installation

Stabilizer Bar Link: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Use an additional wrench to prevent the ball joint rotating.
  1. Install the stabilizer bar link.
    • Tighten the nuts to 48 Nm (35 lb.ft).
  2. Install the wheel and tire. Refer to WHEEL AND TIRE - Removal and Installation.
scientia non olet · About LEMON Manuals