LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Rear Suspension) >> Rear Suspension >> Removal And Installation >> Rear Wheel Bearing >> Removal

Rear Wheel Bearing: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Make sure to support the vehicle with axle stands
  1. Raise and support the vehicle.
  2. Remove tire, refer to WHEEL AND TIRE information.
  3. See figure
    GJ0023255
  4. See figure
    GJ0023256
  5. See figure
    GJ0009004
  6. See figure
    GJ0023257
  7. See figure
    GJ0023258
  8. See figure
    GJ0023259
    9. CAUTION: Do not use a hammer to detach the halfshaft from the hub assembly, failure to follow this instruction may result in damage to the halfshaft.
  9. Hub puller (205-491)

    Adapter nuts (205-491-1)

    Flange remover forcing screw (204-269)

    GJ0023260
    10. NOTE: Use an additional wrench to prevent the component from rotating.
  10. See figure
    GJ0023261
  11. Remover/Installer, Wheel Bearing (204-726)

    Remover/Installer, Wheel Hub (205-725)

    GJ0023262
  12. Remover, Wheel Bearing (204-305)

    Remover/Installer, Wheel Bearing (204-726)

    Remover/Installer, Wheel Hub (205-725)

    GJ0023263
  13. See figure
    GJ0023264
  14. Remover/Installer, Wheel Bearing (204-726)
    GJ0023265
scientia non olet · About LEMON Manuals