Rear Wheel Bearing: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Installer, Wheel Bearing (204-727A)
Installer, Wheel Bearing (204-791)
- See figure
- Remover/Installer, Wheel Bearing (204-726)
Wheel bearing install and removal tool (204-250)
- Torque: 96 Nm
- See figure
- Torque: 190 Nm
- Torque: 63 Nm
- Torque: 6 Nm
- See figure
- Torque: 103 Nm
- Torque: 300 Nm
- Refer to WHEEL AND TIRE - Removal and Installation.
NOTE:
Make sure correct alignment of the bearing is maintained when installing into the hub carrier.
NOTE:
Make sure the correct alignment of the drive flange is maintained when installing into the hub carrier and bearing assembly.
CAUTION:
The final tightening of the suspension components must be carried out with the vehicle on its wheels.
CAUTION:
Install the halfshaft nut finger tight.
NOTE:
The wheel hub nut is not tightened at this stage.
CAUTION:
The final tightening of the suspension components must be carried out with the vehicle on its wheels.
CAUTION:
The final tightening of the suspension components must be carried out with the vehicle on its wheels.
CAUTION:
Do not use air tools to install the nut. Failure to follow this instruction may result in damage to the component.