Lower Arm: Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
NOTE:
Removal steps in this procedure may contain installation details.
- Raise and support the vehicle.
- Refer to WHEEL AND TIRE - Removal and Installation.
- Torque: 103 Nm
- See figure
- Torque: 48 Nm
- Torque: 133 Nm
- Torque: 150 Nm
- Torque: 192 Nm
- Torque: 192 Nm
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
WARNING:
Make sure that a new nut is installed.
NOTE:
Use an additional wrench to prevent the component from rotating.
CAUTION:
Make sure the wheel knuckle is supported. Failure to follow these instructions may result in damage to the vehicle.
CAUTION:
Make sure that a new bolt is installed.